Worthington Distribution Knowledge Base

Adding Z-Wave Locks and thermostats to Home Center

This article applies to Home Center 2 and Home Center Lite.

  1. Navigate to the Devices button on the top menu ribbon
  2. Look for Devices in the left menu and click Add or Remove Device just below it
    1. This brings you to the add device screen
  3. IMPORTANT: Check the box labeled Add in security mode if device supports itAdd Lock
  4. Click the Add button in the top section of the page
    1. The Add Device box will pop up
  5. Put your lock into inclusion mode and wait for the Add Device box to go away
  6. Return to the Device screen and locate your new lock
  7. Click on the wrench to get to the device settings
    Fibaro Settings Icon
  8. Name your device and assign it to a roomFibaro Lock Settings
  9. Click the save button in the menu bar on the right

 Video Tutorial (go to 6:15 for locks):

Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Setting up Notifications
Viewed 373 times since Wed, Jan 18, 2017
Adding Z-Wave Lighting Devices, Sensors, and Thermostats to Home Center
Viewed 696 times since Wed, Jan 18, 2017
MENU