Worthington Distribution Knowledge Base

Synchronizing on the Zipato Controller

There are a total of 3 sync points you need to be aware of.  One sync does not do it all.

During install and programming, you will be using all 3.  After that, typically syncs would only be needed on the app(s).

 

When using the Web Interface:

You have a sync point on the LEFT for whenever you add, remove, or configure a device (any changes on the left side)

You have a sync point on the RIGHT any rules you add, remove, or revise a rule (any changes on the right side)

A good habit would be to sync on both sides whenever using the web interface.

 

On the App:

Note: The hardware of the Zipatile and the Zipato app running on it do not automatically sync.  So, after any changes done elsewhere (web or remote app), you will need to sync the Zipato app on the Zipatile as well.

 

The app (on the Zipatile or the phone) has a Sync point in the MENU.  This syncs the app to the "box" ( hardware of the tablet/box).  This would be used whenever a change is made either from the web or from an app running on another device.

The user will use this sync to update the settings and readings on the app.

 

Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Using the Aeotec Wallmote with SmartThings
Viewed 16125 times since Tue, Mar 21, 2017
Z-Wave Shades – Zipato Micromodule Motor Controller with Zipato
Viewed 2327 times since Wed, Jul 12, 2017
Temperature sensing with the Fibaro Door/Window contact
Viewed 3832 times since Thu, Apr 21, 2016
Schlage 468 Z-Wave Lock Integration With Leviton VRC0P Serial Interface
Viewed 8140 times since Thu, Mar 9, 2017
Zipato Rules Creator Overview
Viewed 4203 times since Wed, Jun 15, 2016
Voice Controlled Automation
Viewed 4879 times since Thu, Jul 20, 2017
Z-Wave common practices and FAQ’s
Viewed 4210 times since Thu, May 12, 2016
Z-Wave Shades – Zipato Micromodule Motor Controller with Vera Controls
Viewed 3068 times since Wed, Jul 12, 2017
Creating a Virtual Thermostat within the Zipato interface.
Viewed 9648 times since Tue, Jul 12, 2016
How to create a Z-Wave network with the Leviton VRC0P-1LZ
Viewed 7034 times since Tue, Jul 26, 2016
MENU